Filter
Top Products
42
English
CD Shuttle Operation
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Shuttles. When operating two or more
changers, they must be connected through the
Multi-Changer Switching device (KCA-400C) to
the TDA-7548E/TDA-7547E. If you use 1
Switching device, you can connect up to 4 CD
player/Shuttles. If you use 2 Switching devices,
you can connect up to 6 CD player/Shuttles.
Press the SOURCE button on the TDA-
7548E/TDA-7547E to activate the CD
Shuttle mode.
Press the AUDIO SEL or SOURCE button on
the Remote Controller RUE-4180 respec-
tively to activate the CD Shuttle mode.
Proceed to Step 3 below to select the
desired player/changer.
SOURCE
A.S.U.
SOURCE
RUE-4180
Press the PROG button on the TDA-7548E/
TDA-7547E to activate the CD Shuttle
Selection mode.
The CD Shuttle Selection mode remains
active for 3 seconds after Step 2 is
performed. Press the PROG button until the
desired CD Shuttle indicator appears on the
display.
Note: If the selected player/changer is not
connected, "NO CHGR-X" will appear
in the display.
BAND
PROG
CHGR-X
BAND
PROG
2 3
1
2
3
1
RUE-4180
TDA-7548E only
1
TDA-7548E only
1
(Remote Control)