Filter
Top Products
6-EN
4 Press the g DN or f UP button to
automatically seek for a station downward or
upward respectively.
The unit will stop on the next station it finds.
Press the same button again to seek the next
station.
Manual Storing of Station Presets
1 Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2 Press and hold any one of the Preset buttons (1
through 6) for at least 2 seconds.
The frequency display will begin to blink.
3 Press the preset button into which you wish to
store the station while the frequency display is
blinking (within 5 seconds).
The display stops blinking once the station has
been memorized. The display shows the band,
preset No. with a triangle (
9) and station
frequency memorized.
4 Repeat the procedure to store up to 5 other
stations onto the same band.
To use this procedure for other bands, simply
select the band desired and repeat the
procedure.
A total of 24 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
AM and D.A.P.).
NOTE
If you store a station in a preset memory which already
has a station, the current station will be cleared and
replaced with the new station.
Radio Operation
TUNE / A.ME
BAND/D.A.P.
f UP
g DN
SOURCE
Preset buttons (1 through 6)
Manual Tuning
1 Press the SOURCE button until radio frequency
appears in the display.
2 Press the BAND button repeatedly until the
desired radio band is displayed.
Each press changes the radio bands as follows:
→ F1 → F2 → AM
3 Press the TUNE button repeatedly until "DX
SEEK" and "SEEK" disappears from the display.
NOTE
The initial mode is DX SEEK.
4 Press the g DN or f UP button to move
downward or upward one step respectively until
the desired station frequency is displayed.
NOTE
"ST" indicator appears when a stereo FM station is tuned
in.
Automatic Seek Tuning
1 Press the SOURCE button until radio frequency
appears in the display.
2 Press the BAND button repeatedly until the
desired radio band is displayed.
Each press changes the radio bands as follows:
→ F1 → F2 → AM
3 Press the TUNE button to illuminate the DX and
SEEK indicators in the display.
With the DX mode activated, both strong and
weak stations will be tuned in the Auto-Seek
operation.
Press again to return to the local mode. The DX
indicator will turn off and the SEEK indicator will
remain illuminated. Now, only strong stations will
be tuned.