ARC Audio XDI 5.2 Car Speaker User Manual


 
Please check the suitability of the installation location
before you begin. Do not cut any of the car’s structure.
Pay attention to the mechanism of the window and door.
If you do not have experience with automotive electrical
and mechanical systems contact a professional
installer. Paying a qualified installer is almost always
cheaper then paying a dealership to repair your car.
After you have found the best location for the woofer,
make or enlarge the mounting hole. Make sure the
opening is just large enough for the woofer to fit tightly
with no gaps. Make sure the surface is flat and that
the speaker does not bind up in the opening. Use an
awl or felt pen to mark the panel and drill the screw
holes without the speaker in place. This will save the
costly mistake of punching a hole in one of your new
speakers. Install the woofer with the grill ring using the 4
screws provided with this system. Firmly seat the grill
into its ring.
Remove the grill from the trim ring first then follow the
steps below installation.
1. Place the speaker in the opening with the trim
ring over it.
2. Screw the trim ring through the panel with the
clips beneath.
3. Install the grill into the trim ring. Add a few drops
of glue if necessary.
4. Snap in the finish ring.
CAUTION:
THE INSTALL
2 3
GRILL
SCREWS
SPEAKER
GRILL RING
PANEL
CLIPS