Filter
Top Products
4 5
Flush Mount
Cut a hole in the panel you wish to install in. Assemble
the tweeter in the mount. Make sure the hole is large
enough for the tweeter and install it through the hole.
Firmly install the retainer to the back of the tweeter.
Reinstall the panel and point the tweeter at a location
between the driver and passenger at ear level.
Surface Mount
Hold the back piece for the mount in place and mark the
screw locations. Pre drill the screw holes and the hole
for the wire. Screw the mount to the panel tightly. Run
the wire through the hole and gently pull it until the
tweeter is fully seated in the mount. Install the retainer
and point the tweeter.
Install the Crossover in a dry location and secure it
firmly. Don’t just drop it in the bottom of the door.
Crossovers
The tweeter comes with 2 different types of mounts.
Flush mount and Surface mount.
Install the Tweeter
Connect the positive and negative to the amplifier
output. Run these wires to the crossover and connect
them to the terminals marked Input +and-.
Connect the Amp
When wiring this system it is important to make all
connections carefully and securely. Follow the instruc-
tions carefully. All audio connections have a + and -. If
one is wired backward the system will play but will
sound strange. One speaker will play Out of Phase
(backwards) from the others. You may notice a loss of
bass response and the vocals will not be in the center of
the sound field.
Wiring
Using the wire provided with the system connect the
positive and negative to the woofer. Run these wires to
the crossover and connect them to the terminals
marked Woofer + and -.
Connect the Woofer
Connect the positive and negative to the amplifier
output. Run these wires to the crossover and connect
them to the terminals marked Tweeter +and-.
Connect the Tweeter