Filter
Top Products
1 INTRODUCTION
FCC Information
This equipment has been tested and found to comply with the limits for a Class B device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation, This equipment
generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be checked by switching the equipment off and on, the user should correct the
interference by one or more of the following measures.
• Move the receiving antenna to a different position.
• Move the equipment and receiver apart.
• Connect the equipment into an outlet on a different circuit.
• Consult the dealer or an experienced radio/TV technician for help.
NOTICE:
• Any changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
• Shielded interface cables and AC power cords, if any, must be used in order to
comply with the emission limits.
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety instructions. Please follow all instructions carefully
during installation. Read this manual thoroughly before attempting to unpack, install or
operate.
Intended for Installation in a Controlled Environment.
Servicing of Batteries Should be Performed or Supervised by Personnel Knowledgeable of
Batteries and the Required Precautions. Keep Unauthorized Personnel Away from
Batteries.
When Replacing Batteries, Replace With the Same Number and Type.
CAUTION- Do Not Dispose of Battery or Batteries in a Fire. The Battery May Explode.
CAUTION- Do Not Open or Mutilate the Battery or Batteries. Released Electrolyte is
Harmful to the Skin and Eyes. It May be Toxic.
CAUTION- A Battery can present a Risk of Electrical Shock and High Short Circuit
Current. The Following Precautions Should be Observed When Working on Batteries:
A. Remove watches, rings, or other metal objects.
B. Use tools with insulated handles.
C. Wear rubber gloves and boots.
D. Do not lay tools or metal parts on top of batteries.
E. Disconnect charging source prior to connecting or disconnecting battery terminals.
2 INSTALLATION OF UPS
1. Unpacking and Check Attached Parts.
a. Unwrap the UPS