9
Do not use a carriage return at the end of the commands. “.” and “%” terminate the commands.
Note: Factory Default settings, when first turned on, are: volume 50, bass 4, and treble 4.
Note: The AT-PA100-G2 has last memory, so if the power is lost the volume, bass, and treble settings
will remain the same as before the power loss.
Command Feedback Description
8xx% Bass of LINE: xx
Preset the bass level, [xx] arranges from [00] to [08].
Example: 803% --> Bass of LINE: 03
9xx% Treble of LINE: xx
Preset the treble level, [xx] arranges from [00] to [08].
Example: 905% --> Treble of LINE: 05
Input Ports 2 x RCA connectors
1 x 3.5mm Audio
1 x 3.5mm IR
1 x Captive Screw MIC
1 x Captive Screw RS-232
Output Ports 1 x Captive Screw Audio
1 x 3.5mm Loop Out
Dimensions (HxWxD) 1.5 x 3.78 x 3.43 (inch) 38 x 96 x 87 (mm)
Weight 0.66lbs 0.3kg
Power consumption 40W
Audio
Gain: 32dB
Frequency Range: 20Hz to 20KHz
Signal/Noise Ratio: 80dB (at max output)
Total Harmonic Distortion: 1% (1KHz), 0.3% (20KHz) -- at nominal levels
Input Impedance: Input 1&2: >10KΩ
MIC Input Impedance: 48V: 35KΩ
MIC: 10KΩ
LINE: 75KΩ
Output Impedance: 3.5mm Loop Out: 50Ω stereo
Speaker out: 4 ~ 8Ω Amplifier
Stereo Channel Separation: >75dB from 20Hz to 20KHz
Common Mode Rejection Ratio: >70dB from 20Hz to 20KHz
MIC Audio Detection Delay: 1ms
Specifications
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515