Filter
Top Products
8
www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
5. If you wish to control the AT-PROHD85M-SR from a 3rd party control system connect an RS-232 cable
between the matrix and the control system. Please use a straight RS-232 Cable for this connection .
(View RS232 codes on page 12)
7. For computer control connect a RJ45 cable to the TCP/IP port of the AT-PROHD85M-SR. Note: If the TCP/IP
port is connected directly to a computer you must use a crossover CAT5 cable. If connect¬ed to a router use
a straight wire CAT5 cable.
8. RS485 port: protocol utilized by compatible control devices to achieve longer distance cable runs over
CAT5
9. Connect the supplied IR receiver cable to the AT-PROHD85M-SR to con¬trol the matrix
switch from the supplied handheld remote control. Used when the AT-PROHD85M-SR is in
an enclosure and the front panel IR window isn’t visible.
10. To manually select an input and output from the front panel follow these steps. Step
1: Press the desired output button. The corresponding output LED will start to flas
Step 2: Press the desired input button. The output LED will change to the input
selec¬tion and will continue to flash.
Step 3: Select the F/N button to enter and the LED will stop flashing.
The AT-PROHD85M-SR remote can control the matrix either through the front
face panel IR receiver window or the supplied IR receiver cable module. If you
use a third party IR remote control you can learn the IR codes off of the matrix
remote. If you use a third party IR remote sys-tem controller you can copy and
paste the IR HEX code into the remote control software package. IR HEX codes
can be found on the supplied CD.
There are 2 scenarios for code use:
1: Learn all 40 x codes in order to control each setup from the matrix location.
2: Learn 8 x codes for local zone control only.
VERY IMPORTANT:
When connecting IR receivers and IR emitters, be very careful as if they are re-
versed the IR Eye will burn-out and also may damage the IR module inside of the
switch and Receiver.
TX – Connects to the Switch
RX – Connects to the HDMI Receivers
IR REMOTE CONTROL