Filter
Top Products
Attaching the Front Panel
Make sure that the faceplate bracket is in the closed position.
Press the faceplate against the front of the unit until it clicks into place.
Initial System Start-Up (Reset)
Figure 1.3 Bracket & Position of Reset Switch
Note The faceplate bracket will automatically close after 10 seconds even
though the faceplate is not detached.
When the faceplate slides down, the unit will turn on if the user presses any
button except [OPEN] or [EJECT].
NOTE: To protect the front panel, place it in the supplied carrying case
when you leave the car
CAUTION
Do not:
Attempt to attach the faceplate to the faceplate bracket when the
bracket is in the open position.
Manually force the faceplate or you may cause damage to the
mechanism that could result in voiding your warranty.
This faceplate is not waterproof.
Expose it to water or excessive moisture.
Remove the faceplate while driving your car.
Place the faceplate on the dashboard or nearby areas where the
temperature rises to high levels.
Touch the contacts on the face plate or on the main unit, since this
may result in poor electrical contacts. If dirt or other foreign
substances get on the contacts, wipe them off with a clean and dry
cloth.To avoid damaging the front panel, do not push it down or place
objects on it while it is open.
Be sure to press the RESET switch if a fatal problem occurs with the unit or during initial
installation. Remove the faceplate to push the reset switch.
Basic Operation
9