Filter
Top Products
27
TROUBLESHOOTING
PROBLEM
IR remote inoperative
Verify that the batteries in the remote are fresh.
Verify that the remote sensor eye is not obstructed.
Disc won't play
No sound or distorted sound
Play starts, but then stops immediately
Can’t advance through a movie
Insert a disc with the label side facing up.
Check the type of disc you put into disc tray. This DVD only plays DVDs, audio CDs
and MP3s.
Both the unit and the disc are coded by region. If the regional codes don’t match, the
disc can’t be played.
Make sure your DVD is connected properly. Make sure all cables are securely
inserted into the appropriate jacks.
If you are using the 2-channel IR headphones, make sure you turn on the IR
headphone power, make sure the correct channel (A-B) is selected.
Make sure the Modulator is ON and the proper Frequency has been selected.
Make sure that unit is set to M1 when using Single Channel Headphones.
The disc is dirty. Clean it.
Condensation has formed. Allow player to dry out.
It can’t advance through the opening credits and warning information that appear
at the beginning of movies because the disc is programmed to prohibit that action.
SOLUTION