Filter
Top Products
5
12. Install and route all video and audio cables, and
any other added component requirements to
their respective places in the vehicle. Refer to
component installation instructions for wiring
diagrams. The suggested routing of the video
system cable is as follows: Above the headliner
from video system to C-pillar. Down the C-
pillar to the floor. Route the power lead to an
accessory controlled source. Connect the
ground lead to the vehicle chassis. Route the
remaining wiring (RCA plugs, Remote Sensor
extension, etc.) to the VCP location. See
Figure 6. Connect per instructions included
with the video system. If video system if to be
used as a television, install an appropriate
antenna per instructions included with the
antenna.
II. INSTALLATION OF CONSOLE
IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED.
13. Raise console (item 6 pg.2) into approximate
position against headliner. Loosely install using (2)
two 6-32 x 3/4" screws (item 1 pg. 2) through the
smaller holes in bracket on console into threaded
clips on front of mounting bracket.
See Figure 7.
14. Using a scribe or similar tool, align hole in rear of
console with slot in rear of mounting bracket.
Loosely secure rear of console using (1) one # 8 x
1 1/2" screw (item 3 pg. 2). Make sure console
alignment is straight then tighten (2) two 6-32
screws previously installed. See Figure 7.
FIGURE 6
FIGURE 7