Filter
Top Products
5
10. Install and route all video and audio cables,
and any other added component requirements
to their respective places in the vehicle. Refer
to component installation instructions for
wiring diagrams. The suggested routing of the
video system cable is as follows: Above the
headliner from video system to B-pillar. Down
the B-pillar to the floor. Route the power lead
to an accessory controlled source. Connect
the ground lead to the vehicle chassis. Route
the remaining wiring (RCA plugs, Remote
Sensor extension, etc.) to the VCP location.
See Figure 6. Connect per instructions
included with the video system. If video
system if to be used as a television, install an
appropriate antenna per instructions included
with the antenna.
II. INSTALLATION OF CONSOLE
IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED.
11. Raise console (item 8 pg.2) into approximate position
against headliner. Loosely install using (2) two 6-32 x
3/4" screws (item 2 pg. 2) through the smaller holes in
bracket on console into threaded clips on front
mounting bracket. See Figure 7.
12. Using a scribe or similar tool, align hole in rear of
console with slot in rear mounting bracket. Loosely
secure rear of console using (1) one # 8 x 1 1/2" screw
(item 4 pg. 2). Make sure console alignment is straight
then tighten (2) two 6-32 screws previously installed.
See Figure 7.
FIGURE 6
FIGURE 7