Filter
Top Products
SETTING THE CLOCK
1. Switch the vehicle ignition and radio on.
2. Momentarily press the Time/Frequency (T/F) Select button
dmdm
dmdm
dm so that the time is shown
on the display panel.
3. Press and hold the Time/Frequency button until the time display begins flashing. While
the display is still flashing, press the Up Tuning
( ) button to adjust the hours and the
A or P indication, then the Down Tuning
( ) button to adjust the minutes to the correct
time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the
unit and the display will return to the normal indication.
If a problem should develop while operating the CD player, an error code (ER-1, ER-2,
ER-3, etc.) may appear on the display panel. This can indicate a number of problems
with the unit, including a mechanical error or an error in the microprocessor control of the
player. If an error code should appear, try ejecting and re-loading the disc into the player.
While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly
(label surface up). You may also try activating the RESET button
dodo
dodo
do on the unit, but this
will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty
station near you for further assistance.
CD PLAYER ERROR CODES
1212
1212
12
SETSET
SETSET
SET
TT
TT
T
ING THE CLOCK/CD ERRING THE CLOCK/CD ERR
ING THE CLOCK/CD ERRING THE CLOCK/CD ERR
ING THE CLOCK/CD ERR
OR CODESOR CODES
OR CODESOR CODES
OR CODES