Audiovox CE-3100 Car Speaker User Manual


 
Cab Wiring
I. Route pre-installed antenna lead to mounting plate for connection to radio later in installation.
2. Locate the two wire (Red and Black) harness and the single Green/White stripe harness in this kit.
3. Connect the Black wire to vehicle ground using the crimp-on ring terminal and screw included.
4. Splice the Red wire to any + 12 volt accessory wire in the cab using the quick splice included.
5. Splice the Green /White stripe wire to any + 12 volt battery source in the cab using the quick splice connector included.
6. Route all three wires to the radio mounting plate for later connection.
(
FIG. 5 CAB WIRNG
CRIMP-ON
RING TERMINAL
~
RED TD + 12 VOLT ACC.
QUICK SPLICE
CONNECTOR
~
BLACK ~
TO VEHICLE
GROUND
/"
GREEN/WHITE WIRE
TO +'12 VOLT BATTER~
(ONLY ON CE1 00/200/300)
"'
,,"
~
RADIO MOUNTING PLATE
~;
Housing Wiring:
I. Connect 2-pin Red/Black plug to mating 2-pin plug.
2. Connect Green/ White wire to mating Green/White wire.
GREEN/WHITE
FIG. 6 HOUSING WIRING
RED
1,,--:
/~
BLACK I
~
GREEN/WHITE
ONLY ON CE10012001300
~
RED
/
BLACK
REAR OF HOUSING