Filter
Top Products
-3-
bl STATION PRE-SET MEMORIES
To set any of the 6 pre-set memory buttons, use the following
procedure:
1. Turn the unit on and select the desired band.
2. Select the first station to be pre-set using the Manual
Up/Down 6 or Automatic Seek 7 Tuning functions.
3. Press the pre-set button to be set and continue to hold the
button in. The volume will momentarily mute and then return
and the pre-set number will appear on the display panel. The
station is now set into the memory of that pre-set button and
can be re-called by momentarily pressing the button.
4. Repeat the above procedure for the remaining 5 pre-sets on
the band in use and for the other 4 bands of the unit.
bm LIQUID CR YSTALDISPLAY PANEL
The Liquid Crystal Display (LCD) panel displays the frequency,
time and activated functions.
NOTE: It is a characteristic of LCD panels that, if subjected to
cold temperatures for an extended period of time, they
will take longer to illuminate than under normal condi-
tions and the visibility of the numbers on the display
may decrease. The LCD read-out will return to normal
when the temperature increases to a normal range.
bnCASSETTE DOOR
Hold the cassette with the exposed tape edge to the right, and
insert into the tape door. Depress fully until the cassette is en-
gaged and begins playing. When the cassette reaches the end
of play, the unit will automatically change over to radio opera-
tion.
NOTE: Observe cassette operation cautions in Care and Main-
tenance section of this manual.
bo F AST-FORWARD/EJECTBUTTON
This button performs two functions. To eject a cassette, simply
depress the button fully then release. The cassette will eject
and radio operation will resume.
To fast-forward the tape, depress the button half-way in to the
locked position. To stop fast-forward and resume normal tape
playback, depress the button slightly and release. Do not press
fully in or the cassette will be ejected.
NOTE: Never leave a cassette engaged in the player when not
in use. Doing so can cause damage to the cassette
and/or mechanism of the unit. Always press the eject
button and remove the cassette before leaving the ve-
hicle.
bp CD/AUXILIARYINPUT SELECT OR (CD)
An auxiliary input jack is provided on the rear of this unit to
accept the audio from an additional source such as a portable
CD player. Connect the audio output from the source unit to the
cable at the rear of the chassis using an appropriate audio patch
cable (available at most radio supply stores). To select play of
the source connected to the input jack, press the CD/Auxiliary
Input Selector button. The indication “Cd” will appear on the
display panel and the input connected to the unit will now oper-
ate through the audio system of the radio. Use the volume,
balance and tone controls of the radio to adjust the sound as
desired.