Filter
Top Products
Pressing either side of the button for longer than 0.5 seconds
and then releasing will activate the Automatic Seek Tuning
function in the selected direction. The radio will seek the next
available station and stop at that frequency. The Seek function
can be stopped by pressing the button again or activating any
other tuning function.
Pressing either side of the button for longer than 0.5 seconds will
cause the radio to continue tuning rapidly in the selected direction
until the button is released, at which point it will seek to the next
available station.
bl LOCAL/DISTANT SELECTOR (LO/DX)
This feature is used to select the strength of the signals at which
the radio will stop during Automatic Seek Tuning. Momentarily
pressing the button will select the Local setting (“LOC” will appear
on the display panel) and only strong (local) stations will be
received. Momentarily pressing the button again will select the
Distant setting (“LOC” will disappear from the display panel) and
the radio will stop at a wider range of signals, including weaker
(more distant) stations.
bm STATION PRE-SET MEMORIES
To set any of the 6 pre-set memories in each band, use the
following procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the Manual Up/Down
or Automatic Seek Tuning Controls 9 .
3. Press the pre-set button to be set and continue to hold it in.
After approximately 2 seconds, the display will flash, the
-4-
volume will be momentarily muted and the pre-set button
number (P1, P2, etc.) will momentarily appear on the display
panel indicating that the station is now set into that pre-set
memory position. The station can now be recalled at any
time by pressing that button.
4. Repeat the above procedure for the remaining 5 pre-sets on
that band and for the other 2 bands on the unit.
bn LIQUID CRYSTAL DISPLAY PANEL
The Liquid Crystal Display (LCD) panel displays the frequency,
time, and activated functions.
NOTE: It is a characteristic of LCD panels that, if subjected to cold
temperatures for an extended period of time, they may
take longer to illuminate than under normal conditions. In
addition, the visibility of the numbers on the LCD may
slightly decrease. The LCD read-out will return to normal
when the temperature increases to a normal range.
bo CASSETTE DOOR
Hold the cassette with the exposed tape edge to the right and
insert it into the cassette door. Depress fully until the cassette is
engaged and begins playing as shown by the tape direction
indication on the display panel. When the cassette reaches the
end on the side of the tape being played, the unit will automatically
change direction of play as shown by the direction arrow and
play the other side of the cassette.
NOTE: Observe cassette operation Cautions in the Care and
Maintenance section of this manual.