Filter
Top Products
128-6266
5 of 16
-5-
audio; however, disc play will continue and not be paused. During
this time, the indication will remain on the display panel to show
that a disc is still loaded in the unit.
bl AM/FM BAND SELECTOR (BAND)
Each time the BAND/LOUD button is pressed momentarily, the
radio band is changed. The indication AM1, AM2, FM1, FM2 or
FM3 will appear on the display panel according to your selection.
bm UP/DOWN TUNE/SEEK/TRACK ( / ) BUTTONS
To manually select a radio station, momentarily press the Up Tuning
(
) button to advance the unit higher, or the Down Tuning
(
) button to tune lower within the selected band.
Pressing either for longer than 0.5 second and then releasing will
activate the Automatic Seek Tuning function. The radio will seek
the next available station in the selected direction and stop at
that frequency. The Seek function can be stopped by pressing
the button again or activating any other tuning function.
bn LOCAL (LOC) BUTTON
This feature is used to select the strength of the signals at which
the radio will stop during Automatic Seek Tuning. Pressing and
this button will select the Local setting (LOCAL will appear on the
display panel) and only strong (local) stations will be received.
Pressing the button again will select the normal Distant setting
(LOCAL will disappear from the display panel, and Dx will be
displayed instead) and the radio will stop at a wider range of signals,
including weaker (more distant) stations.
bo FM MONO/STEREO BUTTON (MONO)
During FM radio operation, this button is used to select mono or
stereo reception of the broadcast signal. Under normal reception
conditions, the unit should be left in the stereo mode as indicated
by the ST indication on the display panel when tuned to an FM
stereo signal. If the stereo signal is too noisy for comfortable
listening, press the MONO button to switch to mono reception (the
ST indication will disappear from the display panel, and MONO will
be displayed). To return to stereo reception mode, press the button
again so that the ST indication reappears in the display.
bp LOCAL STATION SCAN (SCAN) BUTTON
Press this button momentarily to commence an scan of the nearby
local stations whose signal strengths are the strongest (the station
number will appear flashing on the display panel during station
search). Press the button again momentarily to stop the Scan
operation and remain on the current local frequency. To return to
one of the frequencies preset into the current band, press the desired
pre-set button.
bq STATION PRE-SET MEMORIES
To set any of the 6 pre-set memories in each band, use the following
procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the Manual
TUNE or Automatic SEEK Controls
bm .
3. Press the pre-set button to be set and continue to hold it
in for approximately 2 seconds. The preset number,
followed by CH (channel), will appear on the display panel