Filter
Top Products
-2-
3
SELECT BUTTON (SEL)
DISPLAYCALL
DISPLAY PRIORITY SELECTOR
IGNITION-OFF CLOCK CALL
SELECT FUNCTION: This button is used to select the audio
function (volume, bass, treble, balance, or fade) to be adjusted
using the Level Control
2
, as well as the indication (time, frequency,
or CD) shown on the display panel.
DISPLAY CALL: During radio operation, a momentary press of
the button will change the display from frequency to clock time.
After 5 seconds, the display will automatically return to frequency
if set to frequency/CD display priority. If the unit has been set to
time display priority, a momentary press of the button will change
the display from time to frequency/CD. After 5 seconds, it will
change back to time display.
During CD operation, a momentary press of the button will change
the display from track number to track elapsed time. Another
press of the button will change to clock time. After 5 seconds,
the display will automatically return to track number if set to
frequency/CD display priority. If the unit has been set to time
display priority, momentary presses of the button will change the
display to track number and then elapsed time. After 5 seconds,
it will change back to time display.
Additional momentary presses of the button will set the unit for
bass adjustment (level number above BAS will flash on display
panel), treble (level number above TRE will flash), balance (BAL
on display), fader ( FAD) or volume (level number). The display
will automatically return to the normal indication 5 seconds after
the last adjustment is made or when another function is activated.
DISPLAY PRIORITY: This unit can be set so that either the clock
time or radio frequency/CD track will normally appear on the display
panel. Use the following procedure to set the display priority:
Clock Time Priority: With radio frequency on the display panel,
press and hold the Select button for approximately 2 seconds
until clock time is shown. The display will now automatically
return to time display 5 seconds after any other radio, CD or
audio function display.
NOTE:Release the button as soon as the display changes from
frequency to time (approximately 2 seconds). Holding the
button in for too long will put the unit into time setting mode
(flashing time display). See section on "Setting the Clock".
Frequency/CD Track Priority: With clock time showing on the
display panel, press and hold the Select button for approximately
2 seconds until the frequency display is shown. The display will
now automatically return to radio frequency or CD track 5 seconds
after any other function is activated.
IGNITION-OFF CLOCK CALL: To check the time with the vehicle
ignition switch in the "off" position, momentarily press the Select
button. The display will illuminate and show the time and then
automatically shut off after 5 seconds.
4
BASS CONTROL
To adjust the bass level, first select the Bass mode by pressing
the Select button
3
so that the level number above the BAS
indication is flashing. Within 5 seconds of choosing the Bass
mode, press the + or – side of the button of the Level control
2
to adjust the bass response as desired. The bass level will be
shown on the display panel from a minimum of –7 to a maximum
of 7 (0 is flat response). The display will automatically return to
the normal indication 5 seconds after the last adjustment or when
another function is activated.