Filter
Top Products
1. Clean the mounting surface in the vehicle.
2. Install the Remote Subwoofer Level Control unit in a convenient location in the pas-
sengers compartment (usually under the dash board in an accessible area). The
Remote Subwoofer Level Control unit can be attached using a velcro attachment or
can be screwed to the dash using sheet metal screws.
3. To use the velcro attachment, remove the adhesive backing and mount a piece of
velcro to the top of the unit. Using another piece of velcro, remove the adhesive backing
and mount the piece of velcro to the dash board. Press the two velcro pieces together
and ensure that the unit is secure.
4. To use the sheet metal screw attachment, select a mounting area for Remote Subwoofer
Level Control unit. Place the unit on the mounting surface and mark the locations of the
four mounting holes.
5. Remove the Remote Subwoofer Level Control unit and drill a 1/8" hole at each of the four
locations.
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION: Before drilling the holes, look at the underside of the mounting surface. Always
check carefully to avoid drilling into wiring, braces, fuel or brake lines.
CHECK BEFORE CHECK BEFORE
CHECK BEFORE CHECK BEFORE
CHECK BEFORE
YOU DRILL !YOU DRILL !
YOU DRILL !YOU DRILL !
YOU DRILL !
6. Secure the Remote Subwoofer Level Control unit to the mounting surface using self-
tapping screws.
7. Attach the RJ-11plug to the connector to the back of the unit. Route cable from the
passengers compartment to the amplifier (usually located in the vehicle’s trunk).
Attach the other RJ-11 plug to Remote Control connector on the amplifier.
-1-
INSTALLATION INSTRUCTIONS