Filter
Top Products
Antenna
Dash Radio
Red RCA (Audio Right)
IR LED:
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Window on the Face of the VCP.
Black
(Ground)
Optional External Speakers
Gray
(Left+)
Green
(Right+)
Accessory
Harness
Item# 2
Yellow RCA (Video)
White RCA (Audio Left)
LEFT
WHITE
RIGHT
RED
Red: +12 VDC
(Accessory Cir.)
Power Harness
Item # 3a
*Refer to Instructions with the RF
Modulator Kit for further details.
FM
Modulator
Optional Hard Wired FM Modulator Output
12 VDC Power and Ground
Black: Ground
Right
Input
Left
Input
Note: cables
exiting the pod
should be routed
as shown.
Mini-Din Connectors
TV antenna
(If applicable)
"Y" Adapter
for use with
Non-Stereo
Installations
Item# 3b
To Secondary AV Monitor
Auxillary
video display
12 VDC Power and Ground
INPUT
VIDEO
LINE
OUT
VIDEO
TO
FACTORY
RADIO
1070610
Wireless FM Modulator
Antenna
choke
Am/Fm
TO
OPTIONAL
ADDITIONAL
MOINTOR
RCA-Female
RCA-Female
Patch Cord
21
Accessory
Harness
Item# 1
RCA-Female
Patch Cord
RCA Male to Male
1) Make the connections to the vehicle for the 12 pin wiring harness.
2) Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main
PCB. (Cover will remain attached at to rivet hole).
3) Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop
on the main PCB and into the Mini-Din Connector on the main PCB.
4) Pull the wire tie loop tight and cut off the excess.
5) Connect the Power Harness to the mating connector on the Video Monitor.
6) Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those
options are being included.
7) Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.
8) Reinstall PCB cover using the 2 screws.
9) Connect and mount the Television antenna, or optional diversity antennas.
10) Verify all functions of the System before final mounting of the finished assembly.
Note: A second VCP or other A/V Component can be connected to the video monitor system using a
second Source Component Harness (purchased separately, part number: 8010730). This second
harness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1=
VCP (right Mini Din on main PCB)
2=
Tuner
3=
2
nd
VCP (or game or future DVD, etc.…. left Mini Din)
4=
Aux Input (RCA jacks on the face of the monitor).
-7-
VOH-642
2
5
4
2