Filter
Top Products
-8-
Wired FM Modulator
Your video system may be equipped with an RF
modulator, that allows you to listen to the VOH681A’s
audio signal by tuning your vehicle’s radio to the
selected frequency, (88.7 or 89.1 - Check with your
installer) and turning on the remote mounted RF
modulator switch. (In most cases this toggle switch
will be located underneath the driver’s side of the
dash, check with your installer for the exact location.)
Whenever the RF modulator is on, broadcast radio
reception will be poor. Turning the remote mounted
toggle switch off will allow normal radio reception.
Audiovox Video Cassette Player (AV1)
In most installations a VCP will be connected to the
“AV1” input. To view a video cassette, turn the
VOH681A On and press the source button on its
control pad until the “AV1” indicator LED illuminates.
The VCP may also be operated with a remote or the
buttons on its face. The VOH681A is now ready to
play the audio and video signals from the VCP if it is
connected to the “AV1” input. Inserting a tape into the
VCP will automaticly turn it on and activate the play
mode. If a rewound tape had already been loaded
into the VCP, prior to its activation, press play on the
VCP or on the remote control to view the tape. For
more information see the operator’s manual
accompanying your VCP.
Video Output
The VOH681A provides a video output for an optional
video monitor(s). (Refer to page 7 of the installation
guide for more details.) This output will provide a video
signal that duplicates the signal displayed by the
VOH681A to an additional monitor or video display.
Please see your installer for more information.