Filter
Top Products
Figure A
1) Make the connections to the vehicle for the 12 pin wiring harness.
2) Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main PCB.
3) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on
the main PCB and into the Mini-Din Connector on the main PCB.
4) Pull the wire tie loop tight and cut off the excess.
5) Connect the 12 pin harness to the mating connector on the Video Monitor.
6) Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those
options are being included.
7) Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.
8) Reinstall PCB cover using the 2 screws.
9) Connect FM radio antenna to the existing vehicle antenna or equivalent using the supplied 144"
Adapter Cable and the "Y" Adapter (Refer to Figure C.)
10) Verify all functions of the System before final mounting of the finished assembly.
Note: A second VCP or other A/V Component can be connected to the video monitor system using a
second source component harness (purchased separately, part number: 8010730). This second har-
ness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1=
VCP (Right Mini-Din on main PCB)
2=
2
nd
VCP (or game or DVD, etc.…. left Mini-Din)
-6-
VOH683
Red RCA (Audio Right)
IR LED :
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Window on the Face of the VCP.
Black
(Ground)
Optional Remote Headphone Stations
Stereo
Headphone Jack
Stereo
Headphone Jack
Gray
(Left+)
Green
(Right+)
Yellow RCA (Video)
White RCA (Audio Left)
Red: +12 VDC
(
Accessor
y
Cir.
)
Power Harness
Item # 4
Black: Ground
Note: cables
exiting the pod
should be routed
as shown.
Mini-Din Connectors
"Y" Adapter
for use with
Non-Stereo
Installations
Item# 5
choke
12 VDC Power and Ground
1070610
FM
Modulator
Auxillar
y
video displa
y
Optional Hard Wired FM Modulator Output
*Refer to Instructions with the RF
Modulator Kit for further details.
TO
OPTIONAL
ADDITIONAL
MOIN TO R
TO
FACTORY
RADIO
Dash Radio
12 VDC Power and Ground
Am/Fm
Antenna
LINE
OUT
VIDEO
Patch Cord
RCA-Female
To Secondary AV Monitor
IN PUT
VIDEO
Right
In put
RCA-Female
Left
In put
RCA-Female
Patch Cord
RIGHT
RED
LEFT
WHITE
RCA Male to Male
Accessory
Harness
Item# 2
Accessory
Harness
Item# 2
21
Power Connector
4 Pin
RCA Male to Male
Connect to FM radio antenna
or equivalent.
12 Pin Power signal
Harness Item #3