Audison LRX 4.300 Car Amplifier User Manual


 
6
POWER SUPPLY PANEL
REMOTE IN
Terminal to connect Remote cable, which comes from the
source and which controls the amplifier switching on. Applied
voltage must be between 7 and 15VDC.
1
REMOTE OUT
Terminal to repeat the switching on control (Remote IN) coming from the source. It is used to
switch on another amplifier or device in the system simultaneously. Available voltage is the same
as the one applied on Remote IN.
2
VCR (optional kit)
Terminals to connect VCR01/VCRA/VCRD adjuster included in VCR01K/VCRAK/VCRDK volume
remote control kits.
3
POWER
Terminal blocks for the amplifier power supply cable connection. Connect positive and negative
poles according to indicated polarities. Holes have 8mm diameter and accept cables up to 3 A.W.G.
max. In order to get the best current transfer, please use power supply cables with as big a section
as possible. audison cable catalogue offers you a complete range of such products which can
satisfy whatever demands; you can also find Maincrimp terminals in it. We strongly recommend
their use because they contain the cable non protected end and allow the terminal block to fasten
all its useful section.
5
FUSE (30A)
Strip fuse. It insures the amplifier general protection. In case the fuse breaks down, please replace
it by respecting its original value.
CAUTION: If you want to protect the system even more, please put a strip fuse onto the cable
which connects the battery positive pole to the amplifier POWER (+) terminal block (see Electric
connections).
4
1
2
3
4
5
IN OUT
REMOTE
FUSE
POWER
FUNCTIONS
19
CONFIGURATION EXAMPLES
+
Subwoofer
+
Subwoofer
Front Rear
+
Tweeter
+
Tweeter
+
Woofer
Woofer
+
Midrange
Midrange
+
Tweeter
+
Tweeter
+
Woofer
Woofer
+
Midrange
Midrange
LRx 4.300
Config. 1
LRx 4.300
Config. 1
LRx 1.400
Config. 4
Rear
Front
Pre Out
Config. 1
FRONT+REAR+SUB