Filter
Top Products
9
1 CHANNEL SPEAKER WIRING DIAGRAM
1 SPEAKER BRIDGED
Fig.3
Speaker Connections
This amplifier can operate in either one, two or three channel mode. The minimum impedance for
single channel (bridged/mono) operation is 4-8 ohms. There channel tri-power is referred to stereo
and mono at the same time. Minimum impedance remain the same for three channel (satellite/
subwoofer) systems as long as proper passive crossovers are used.
Connect right and left speaker wire to corresponding speaker output terminals of the amplifier.
Be sure to have the positive wire from the speaker to the positive speaker terminal of the amplifier
and the negative wire from the speaker must connect with the negative speaker terminal of the
amplifier. Reversing any of these connections will result in the speaker cones moving out of phase
which causes bass cancellation. See Fig.3 Speaker Output Connections.
POWER
+12VDC REM GND
FUSE
SPEAKER
2-8 Ohms
1 CH