Filter
Top Products
CONTENTS
PRACTICE SAFE LISTENING
System Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 4,5
Mounting The Bazooka . . . . . . . . . . . . . . . . . . . . . . . . . .pg 6,7,8
Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 9
Power Wire . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 10
Ground Wire . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 11
Remote Turn On Options . . . . . . . . . . . . . . . . . . . . . . . . .pg 11,12
Input Signal Connections . . . . . . . . . . . . . . . . . . . . . . . .pg 13,14
Adjusting Level Gain . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 14
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 14
Continuous exposure to high volumes of sound may cause permanent hear-
ing loss. High powered auto sound systems are capable of producing
sounds well over 130 dB. Even short periods of play at high volume levels
can impair your ability to hear necessary traffic sounds and may constitute
a hazard. Please use common sense and practice SAFE LISTENING !
If you have any questions contact
the SAS Technical Support Department at:
Phone - (504) 272 7135 • Fax - (504) 272-9844
Email - tech@ sasbazooka.com • Website - www.sasbazooka.com
In Canada: (604) 988 2966
15049 Florida Blvd., Baton Rouge, LA. 70819
2
Should I Use High or Low Level Inputs?
If the source unit has only speaker outputs, use the high-level inputs of the
Amplified Bazooka. If the source unit has both high and low level outputs, we
recommend using the high level inputs over the low level inputs, due to the con-
figuration of the Amplified Bazooka's balanced input circuit. PLEASE NOTE
THAT THE WIRING IN A FACTORY STEREO MAY NOT BE ELECTRICALLY IN
PHASE EVEN WHEN YOU HAVE MADE THE PROPER CONNECTIONS.
Take the time after you make your wire connections to run through the quick
phase check procedure in the AM I IN PHASE? Section of this manual. NEVER
USE BOTH high and low-level inputs at the same time!
High-Level Inputs:
If the source unit has both front and rear speaker outputs, use only one set of speak-
er outputs for the high-level input of the Amplified Bazooka. Connect the GREEN
wire from the 14-pin Molex plug of the Amplified Bazooka to the source units left
(+) positive speaker output. Connect the GREEN W/BLACK stripe wire of the plug
to the source units left (-) negative speaker output. Connect the GRAY wire of the
plug to the source units right (+) positive speaker output. Connect the GRAY
W/BLACK stripe wire of the plug to the source units right (-) negative speaker output.
INPUT SIGNAL CONNECTIONS
PHASE ALERT
13
Am I In Phase?
If your inputs are out of phase and you turn the balance control of your
radio all the way to one side, right or left, the bass output from the
Bazooka will increase. When you bring the balance control back to the
center position the bass level will drop. This confirms that one of your input
When one of the Amplified Bazooka's High-level Input channels is out of
phase electrically with the other High-level Input channel your Bazooka will
sound as if it has little or no output, and any output that is produced may
sound distorted. . If you suspect that your Bazooka is out of phase, use the
AM I IN PHASE procedure to diagnose and correct the Bazookas' output,
and proper bass response will be produced.