Filter
Top Products
Red
Black
RCA
Green/White
Orange
RCA
Brown/Grey
POWER WIRE (NOS8A only)
The power wire must be fused and connected directly to the positive
terminal of the battery to provide a power source with a low voltage
drop and low noise. Do not make the power connection at the fuse
block or any point other than the battery. Improper power sources can
reduce output and cause distortion.
The fuse holder should be connected to the battery's positive terminal.
The fuse is designed to prevent fire or damage to your car, should the
battery wire short to ground. Wait to insert the fuse into its holder
until all wire connections have been made.
If it is necessary to lengthen the battery wire, add the required length
between the amplifier and the fuse holder, not the fuse holder and
the battery. If you need to extend the battery wire, use 12 gauge or
larger for NOS8A, it is best to use as short a wire as possible. Be sure
you DO NOT run the power wire next to the input cables of the amplifier,
this will induce noise. Avoid running the power wire near the radio's
9
WIRING DIAGRAM (NOS8A Only)
RED 12 GAuge
BLACK 12 Gauge
Orange 16 Gauge
Green/White RCA
Brown/Grey RCA
+ 12 Volt Battery
Chassis Ground
Remote Turn-On
Right RCA Input
Left RCA Input