Filter
Top Products
5
FINISHING THE LOOK (Step 1)
In order to complete the look of your subwoofer, you will need to install
the included wire loom over the wire and attach the nozzle to the top of
the tank.
To begin, the wiring needs to be routed THROUGH the nozzle. If necessary,
begin by feeding the wire through the nozzle as shown in the picture
below. Continue feeding wire through as you push the nozzle into the top
of the tank until you hear a click. On the NOS8A, the amount of
wiring and small area of the nozzle can make this difficult. To make
this easier, Bazooka recommends twisting the nozzle assembly
around to make the wiring coil up inside the nozzle and take up
less space. Be sure not to rotate the nozzle so much that it pulls
the wires loose from their connections. Usually, one-and-a-half
turns is all that is necessary.
On the NOS8A, you will also need to install the valve knob onto the gain
control at this point.
Valve Gain Knob
Twist if Necessary