Filter
Top Products
Page 4 of 4
Confi dential, for internal use only. Not to be reproduced.
©2011 Red Chip Company Ltd. Technical specifi cations and appearance subject to change without notice. The information contained herein is correct at the time of printing. All trademarks are the property of their respective owners. BEHRINGER accepts no liability for any loss which
may be suff ered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. 985-10000-00383
For service, support or more information contact the BEHRINGER location nearest you:
Europe Tel.: +49 2154 9206 4149
Fax: +49 2154 9206 4199
USA/Canada Tel.: +1 425 672 0816
Fax: +1 425 673 7647
Singapore Tel.: +65 6845 1800
Fax: +65 6214 0275
Australia Tel.: +61 03 9877 7170
Fax: +61 03 9877 7870
Japan Tel.: +81 3 5281 1180
Fax: +81 3 5281 1181
OUTPUT POWER
20 Hz – 20 kHz @ 0.1% THD, both channels driven
EP4000
8 Ω per channel 550 W
4 Ω per channel 950 W
2 Ω per channel 1250 W
EP2000
8 Ω per channel 350 W
4 Ω per channel 500 W
2 Ω per channel 650 W
RMS @ 1% THD (sine wave), bridged mode
EP4000
8 Ω 1750 W
4 Ω 2400 W
EP2000
8 Ω 1000 W
4 Ω 1300 W
Peak Power, both channels driven
EP4000
8 Ω per channel 750 W
4 Ω per channel 1400 W
2 Ω per channel 2000 W
EP2000
8 Ω per channel 400 W
4 Ω per channel 750 W
2 Ω per channel 1000 W
Peak Power, bridged mode
EP4000
8 Ω 2800 W
4 Ω 4000 W
EP2000
8 Ω 1500 W
4 Ω 2000 W
EP4000
Distortion <0.02%
EP2000
Distortion <0.01%
Frequency Response
At 10 dB below rated 20 Hz – 20kHZ, +0/-dB
output power
At -3 dB points 5 Hz – 50 kHz
EP4000/EP2000
Damping Factor >300 @ 8Ω
Noise Unweighted, 20 Hz to 20 kHz -100 dB
Voltage gain
EP4000/EP2000 40X (32 dB)
EP4000/EP2000 50X (34 dB)
Input sensitivity
VRMS (@ 8 Ω) 1.15 V (+3.4 dBu)
Input Impedance 10 kΩ unbalanced, 20 kΩ balanced
Controls
Front Power switch, gain control
(channels 1 and 2)
Rear DIP switches (10x)
Indicators
POWER green LED
CLIP red LED, 1 per channel
SIGNAL yellow LED, 1 per channel
Connectors
Inputs Balanced XLR and ¼" TRS connectors
Outputs Touch-proof binding posts and
professional speaker connectors
EP4000/EP2000
Cooling Continuously variable speed fan,
back-to-front air ow
Ampli er protection Full short circuit, open circuit, thermal
and HF protection Stable into reactive
or mismatched loads
Load protection Turn-on/o muting, AC coupling
EP4000
Output circuit type Class H complementary linear output
EP2000
Output circuit type Class AB complementary linear output
POWER SUPPLY
EP4000/EP2000
Mains Voltage/Breaker 100-120 V~, 50/60 Hz 15A
220-230 V~, 50/60 Hz 8A
EP4000
Power consumption 2600 W
EP2000
Power consumption 1600 W
EP4000/EP2000
Mains Connector Standard IEC receptacle
DIMENSIONS/WEIGHT
EP4000/EP2000
Dimensions (HxWxD) approx. 3.5 x 19 x 15.8"
approx. 88 x 483 x 402 mm
EP4000
Weight approx. 36.6 lbs / 16.6 kg
EP2000
Weight approx. 34.6 lbs / 15.7 kg
Please note these speci cations are preliminary and conceptual in nature,
and as such are subject to change as product development progresses.
This information is supplied for market research purposes only and is not
to be made public in any manner. This document is solely the property of
The MUSIC Group, or one of its subsidiaries, and must be surrendered upon
request of the owner.
EUROPOWER
EP4000/EP2000