Filter
Top Products
ACD 9431
16
Balance and Fader Control
Balance control
To balance the sound level left/right:
• Press the AUD button 2 until bal is
shown on the display.
Press rocker switch < > 7 on the left
or right to adjust the sound impression
according to your personal preferences.
Display 9 gives you a number bet-
ween -9 and +9.
Fader control
To balance the front/rear sound level:
• Press the AUD button 2 until fad is
shown on the display.
Press rocker switch < > 7 on the left
or right to adjust the sound impression
according to your personal preferences.
Display 9 gives you a number bet-
ween -9 and +9.
Note:
If the rocker switch < > is kept depressed (on
the left or right), the set quickly advances to
the final values (+7/+9 or -7/-9) or to the “0”
position.
Radio Section
Selecting the Desired Waveband
With this set you have free choice from the
following wavebands:
FM (ultra-short wave; frequency-modulated),
MW (medium wave), and LW (long wave).
Selecting FM
• Press the FM•T button 3 briefly. “FM”
lights up on display 9 a.
Selecting MW or LW
• Press the M•L button 4 briefly. Either
“MW” (for medium wave frequencies) or
“LW” (for long wave frequencies) lights
up on display 9 g, c.
For changing between MW and LW:
• Press the M•L button 4 once again.
Tuning in a Station Automatical-
ly
Tuning in the following station
• Press the < > rocker switch 7 on the
right. The car stereo automatically
starts searching for the next station.
Tuning in the previous station
• Press the < > rocker switch 7 on the
left. The car stereo automatically starts
searching for the previous station.
If the < > rocker switch 7 is kept de-
pressed on the right or the left, the sta-
tion seek operation continues to be
carried out quickly in the corresponding
direction.
Manual Tuning
To manually tune in a station,
• press the lo•m button 5 until “m” lights
up on display 9 f.
You can now manually search for the desired
stations via the < > buttons 7.
Adjusting the Station Seek
Sensitivity
With this set you can modify the automatic
station seek sensitivity in all wavebands.
If you want to search for strong stations only
(reduced sensitivity):
• Press the lo button 5 until “lo” lights
up on display 9 e.
If you also want to search for weaker stations
(increased sensitivity):
• Press the lo button 5 once again; the
“lo” indication on display 9 e goes out.