Filter
Top Products
15
Rhodos CC 25 gb
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Restart following interruption of
power supply
(Code system switched on)
• Switch on the set.
“COD” will appear in the display.
• Briefly press preset button 1, “000” will
appear in the display.
• Enter the code number given in the
Blaupunkt car radio passport:
Preset button 1 only allows to choose
“0” or “1”. The first “0” will not be dis-
played.
Example: the code number is 0521.
- Press preset button 1 until “000” ap-
pears in the display.
- Press preset button 2 five times,
“500” appears in the display.
- Press preset button 3 twice, “520”
appears in the display.
- Press preset button 4 once, “521”
appears in the display.
• To confirm the code number:
Press the
upper part of the rocker
switch
.
Your car radio is now ready for operation.
If three dashes appear again in the display,
you have entered a wrong code number.
Now it is essential to enter the correct code
after the waiting period has elapsed (COD in
the display).
Anti-theft coding
The car radio comes standard with the code
system deactivated.
If the anti-theft coding system is on while the
power supply to the unit is interrupted (e.g.
theft, disconnecting the car battery), the set is
electronically blocked. Then it may only be
used again after the appropriate code num-
ber has been entered (see car radio pass-
port).
Wrong code number entered
It should not be possible for thieves to ascer-
tain the code number by trial-and-error. This
is why the set will be blocked for a certain
period of time, if an incorrect code number is
entered. In this case, “- - -” will appear in the
display.
This waiting time is 10 seconds after the first
three attempts, and 1 hour following subse-
quent attempts.
After 19 unsuccessful attempts, “OFF” will
appear in the display and the set can no
longer be restarted.
Note:
Keep you car radio passport with the code
number in a safe place in order to avoid
“unauthorized access” to your car radio.
If the power supply to the radio is interrupted
while the code system is switched on, you
need to know the right code number.
The radio will operate again as soon as you
have entered the right code number.
If you lose your radio passport and have
forgotten your code number, you will not be
able to restart the set after the power supply
has been interrupted. In this case, your radio
can only be reset in our central customer
service workshop or in one of our service
agencies abroad.
Switching the code system on
Precondition:
The radio must be connected to permanent
power.
In order to switch the code system on:
• Turn the radio off.
• Hold down the preset buttons 1 and 4
simultaneously.
• Turn the radio on.
“COD” briefly appears before the radio
begins to operate.
• Release preset buttons 1 and 4.
The code system is on.
“COD” will be briefly displayed each time the
radio is turned on.