Filter
Top Products
18
FITTING
Carefully cut open the headrest
cover
Use a knife with an adjustable cutting
depth to cut out the planned area.
➮ Make the first cut inside the marked
area at a point about 0.5 cm from one
of the corners, then make a diago-
nal cut to a point about 0.5 cm from
the opposite corner.
➮ Make a similar cut between the oth-
er two diagonally opposed corners.
Open the headrest and remove
filling and other items
➮ Carefully lift the covering material
away from the cut area.
➮ Adjust the cutting depth of the knife
to about 2.5 cm, and cut into the he-
adrest following a line about 0.5 cm
inside the marked edge.
➮ Carefully lift the filling material at one
corner, and cut deeper into the ma-
terial with the knife.
➮ Remove the filling material in small
pieces.
➮ As you do this, lift one piece of the
filling material, and ensure that the
cut is being made to an even depth.
To remove other pieces, use a Dremel
saw or another suitable tool.
➮ Insert the monitor to check that it will
fit into the cut area, and make ad-
justments if necessary.