Blaupunkt IVMS-7001 Car Video System User Manual


 
DANSK
15
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
FITTING/REMOVAL
Mark out the dimensions
Feel the covering of the headrest
carefully to ensure that there are
no invisible parts that would pre-
vent the monitor from being fitted.
Use the cardboard template provided
to mark out the area that will need to be
cut.
Carefully cut open the headrest
cover
Use a knife with an adjustable cutting
depth to cut out the planned area.
Make the first cut inside the
marked area at a point about
0.5 cm from one of the corners,
then make a diagonal cut to a point
about 0.5 cm from the opposite
corner.
Make a similar cut between the
other two diagonally opposed cor-
ners.
Open the headrest and remove
filling and other items
Carefully lift the covering material
away from the cut area.
Adjust the cutting depth of the knife
to about 2.5 cm, and cut into the
headrest following a line about
0.5 cm inside the marked edge.
Carefully lift the filling material at
one corner, and cut deeper into the
material with the knife.
Remove the filling material in small
pieces.
As you do this, lift one piece of the
filling material, and ensure that the
cut is being made to an even
depth.
To remove other pieces, use a Dremel
saw or another suitable tool.