Filter
Top Products
63
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Setting the colour of the
display illumination
You can adjust the colour of the display
illumination to suit the illumination of
your vehicle cockpit. The primary col-
ours red, green and blue (R-G-B) are
available for this.
Setting a colour for the display
illumination
➮ Press the MENU button 7.
➮ Press the or button 6 repeat-
edly until “DISP COL” appears in
the display.
➮ Press the or button 6.
The menu for adjusting the colours is
displayed. “R”, “G” and “B” are displayed
with the current values. The “R” setting
flashes.
➮ Press the or button 6 repeat-
edly until the setting that you want
is displayed after “R”.
➮ Press the or button 6 to
move the selection cursor to the
position after the other colours (“G”
or “B”).
➮ Adjust the other colours to suit your
preferences.
When you have finished adjusting the
setting,
➮ Press the MENU button 7 twice.
The settings are saved.
Selecting a display illumination
colour during a scan
You can select the colour of the display
illumination during a “scan”. During the
scan, the display shows all the possible
colour variations that are available in the
RGB spectrum. The scan takes approx.
40 seconds.
➮ Press the MENU button 7.
➮ Press the or button 6
repeatedly until “COL SCAN”
appears in the display.
➮ Press the or button 6.
The colour scan begins. All the possi-
ble colour variations that are available
in the RGB spectrum are shown in the
display one after another.
If you want to select the display illumi-
nation colour that is currently being
shown,
➮ press the MENU button 7.
The settings are saved.
If you want to cancel the scan without
setting a new colour,
➮ press the or button 6.
Note:
● If you do not press a button, the
scan will stop after cycling through
the colours once (approx. 40 sec-
onds) and the previously selected
colour will be applied as the setting
again.
DISPLAY ILLUMINATION
02BrooklynMP35_gb 19.08.2005, 14:45 Uhr63