Blaupunkt RCM 85 Car Stereo System User Manual


 
27
Casablanca RCM 85
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Press the FMT button as many times
until the desired memory bank lights up
in the display.
Storing stations
On FM, you can store six stations on the
preset buttons 1 to 6 for each of the memory
banks I, II and T.
On MW/LW, you can store six stations each.
Select the waveband with FM
T or M•L
and on FM also the desired memory
bank (with FM
T).
Tune in a station with the rocker switch
(either automatically or manually).
Press the desired preset button until
the radio resumes play after the muting
(takes approximately 2 seconds, confir-
med by beep).
Now the station has been stored.
The activated preset button is indicated in the
display.
Notice:
Should you tune in a station which has alrea-
dy been stored before, the corresponding
preset button and the memory bank will briefly
flash in the display if you have selected
another memory bank.
Automatic tuning
Up
Down
/ Up/down in short intervals
(“AF” must be switched off)
/ To scroll through the broadcasting
network when “AF” is activated
(e.g. NDR1 ... NDR4).
Manual tuning << >>
(prerequisite: AF is switched off!)
Press << >>; the frequency will change
in short intervals in downwards or up-
wards direction.
When holding the right or left part of the
rocker switch pressed down, the frequency
scan is speeded up.
Scrolling through the broad-
casting network (only FM)
You can use the << >> buttons to tune in
stations of your reception area.
If several programmes of one broadcasting
network can be received, you can scroll
through them in forwards direction pressing
>>, or backwards using the << button, e.g.
NDR 1, 2, 3, 4, N-JOY (North German broad-
caster).
For this it is necessary that the stations have
been received at least once and that “AF” has
been activated before (lights up in the dis-
play).
For this purpose, you may start Travelstore
seek operation:
Press FM
T for 2 seconds; the system
starts to run through the frequency
band.
If “AF” does not light up,
press AF.
With this, the requirements for selecting sta-
tions with << >> are fulfilled.
Changing the memory bank (FM)
You can shift between the memory banks I, II
and T in order to store stations and recall
them later.
The currently selected memory bank is indi-
cated in the display.