Filter
Top Products
52
• After having updated the last CD or
magazine, press TPM for approximate-
ly two seconds (beep).
To quit the function,
• press DSC.
The system has saved the TPM information
for all of the CDs which were inserted. For
all other discs, the TPM information and CD
names have been deleted.
DSC programming
DSC (Direct Software Control) allows you
to customise certain programmable, basic
settings to suit your personal needs and
preferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to these if desired.
If you wish to alter any of the programming,
• press DSC.
Use the rocker switch and the
button to
select and adjust the functions described in
the following. The display will show you the
adjusted condition.
/ Select function
<< >> Adjust/recall value
CD/CDC NAME
Only available for CD/CDC
playback.
Use this function to name
your CDs. (See “Entering
CD names”).
LOUDNESS Loudness - When listening
at a low level, the Loudness
function creates a more nat-
ural sound by boosting the
low frequency range.
LOUD 1 - Low boost
LOUD 6 - Max. boost
TA VOL To adjust the traffic an-
nouncement and warning
beep volume from between
0 to 63.
The message will then come
through at this volume, if the
standard volume is lower.
Should the standard volume
be higher than the TA VOL
level, then the traffic report
will be played slightly louder
than the standard volume.
Toronto RDM126 gb® 03.06.2002, 12:55 Uhr52