Bogen A2 Car Speaker User Manual


  Open as PDF
of 4
 
WARNING: Mounting brackets must be secured in accordance with local codes. If in doubt, consult a
professional contractor to determine the integrity of the structure to which the bracket will be attached.
When required, a user-supplied safety strap can be secured to the back of the speaker cabinet using the
threaded brass insert and supplied screw.
MULTIPLE SPEAKERS AND SOUND COVERAGE
Placement is critical when the goal is smooth, even sound coverage of an area. Horizontal and vertical
dispersion usually vary with 2-way speakers, so installation orientation should be consistent. Models A6 and A8
deliver about 110 and 100 degrees of horizontal sound coverage, respectively, while the coaxial A2 provides
about 90 degrees.Too great a distance between any 2 speakers will create a dead spot in the coverage.When
in doubt, use more speakers to ensure adequate coverage.
OTHER FACTORS TO CONSIDER
Distance is not the only factor affecting sound intensity. Others that should be considered in the planning
phase are adjacent surface reinforcement and environmental effects such as temperature extremes and
humidity (mainly in outdoor installations).
LOW FREQUENCY OUTPUT
Bass output level depends on a speaker’s location.The more reflecting surfaces in proximity to the speakers
(walls, ceilings, floors), the greater the bass output.Therefore, speakers mounted in free space (e.g., hanging
from an overhead support) will produce comparatively less bass output.
UNDERPOWERING VS. OVERPOWERING
Most speaker damage is caused by amplifiers with too little power.An overdriven amp sends clipping distor-
tion to the speakers. Clipping is usually audible; it may vary from a harsh sound to a fuzzy or blurry sound. If
you hear clipping at loud volume levels, turn down the volume until the distortion is no longer present.
Damage caused by operating the speakers at distorted volume levels is not covered by the warranty.
PAINTING
The speaker cabinet and grille can be painted with a thin coat of spray paint. Remove the grille and mask the
speaker assembly so that only the cabinet gets painted. Then, if desired, spray the grille lightly to avoid
plugging the holes.
MAINTENANCE
None required. Speaker cabinets can be wiped clean with a soft, damp cloth.
NOTE:The total number of speakers multiplied by the tap value cannot exceed the output power (in watts)
of the 70V amplifier.The above example shows 5 speakers. Using the 16W taps, you need an amplifier with
at least (5) x (16) = 80W.A good rule of thumb is to select an amplifier with 20% greater power; in this case,
an amplifier that delivers about 100W.
Observe correct
polarity for maximum
bass performance.
BACK PANEL OF 70V MODELS
EXAMPLE OF 70V SYSTEM CONFIGURATION
EXAMPLE OF 8
ΩΩ
SYSTEM CONFIGURATION
BACK-PANEL CONNECTIONS
BRACKET INSTALLATION
BACK PANEL OF 8
ΩΩ
MODELS
NNEEAARR
AA-SSEERRIIEESS
EENNVVIIRROONNMMEENNTT-PPRROOOOFF
IINNDDOOOORR//OOUUTTDDOOOORR
LLOOUUDDSSPPEEAAKKEERRSS
 previous next