Filter
Top Products
50 Spring Street, Ramsey NJ 07446
Tel. 201-934-8500, Fax: 201-934-9832
www.bogen.com
Speaker Installation
STEP 1 - For easier installation, remove the flange (base)
from the speaker by unscrewing the wing nut while at the
same time pressing inwardly on the wing nut. Place the flange
flush with the mounting surface and mark the location of the
three holes with either a marker or chisel. It is important that
the three holes be exactly aligned with the flange, otherwise
you might stress the base or make the connection unsteady.
Drill the necessary holes and screw the flange to the surface
(see Figure 3). (Use appropriate hardware for your specific
mounting surface.)
NO
TE: The speaker may also be strap-mounted using
standard 1/2-inch industrial strapping.
STEP 2 - After mounting the flange, reattach the speaker to
the flange and aim the speaker for the desired coverage. A 45
downward angle is recommended, but this may vary depend-
ing upon speaker layout and floor plan.
STEP 3 - Remove the plastic cover to make the electrical
connection and set the volume control (see Figure 4).The sug-
gested amplifier connections are:
Amplifier Outputs Speaker Connections
70V Terminal 1
COM Terminal 2
NO
TE: The speaker will also work perfectly well with these
connections reversed. However, it is important to be
consistent in the wiring of the speakers in the system.
STEP 4 - Adjust the volume control to the desired setting.
See Figure 2 for the suggested initial settings based on the
ambient noise level of the environment. Place the protective
cover back over the exposed area.
NO
TE:The two furthermost clockwise settings on the volume
control will produce the same volume.
Figure 3
Figure 4
ELECTRICAL
CONNECTION
VOLUME
CONTROL
o