Filter
Top Products
8 of 12
ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05
When attaching the horizontal support (S) to wall arm or
ceiling plate, carefully thread retaining collar (O) onto end of
flush mount (T) tube (or extension column). Tighten at least
four complete turns ending with one of the small threaded
holes aligned with slot in the end of flush mount tube (T) (or
extension column). Insert and tighten one M5 screw (F).
T
S
F
O
DETAIL 3
(BOTTOM VIEW)
S
TILT CLEARANCE
Adjust TV to desired tilt then tighten screws. Maximum tilt
is 30°. If tilt clearance is a problem revisit step 7, DETAIL 2.
• Set screw (F) is self tapping and may be hard to get
started but is essential to this installation. Failure to
install this screw can cause the mount to fall.
WARNING
• Tighten all screws securely.
WARNING