Filter
Top Products
Installation - Wiring
5
Amplifier Fuses
Although the amplifier has an internal fuse (s), additional fuse protection
should be installed as close as possible to the battery on the positive (+) power
wire going to the amplifier. An inline fuse should be installed at no more than
18" (46cm) on the positive (+) power wire. The rating of the inline fuse should
equal the value of the internal fuse of the amplifier if only the single amplifier is
connected to this wire. If other devices are connected to this wire, the fuse
value should be of sufficient capacity to handle the demand.
Wire Gauge
The amplifier accepts up to 4-gauge (8-gauge on GTA-500m) stripped wire at
the DC power and ground input terminals, and 4-gauge (8-gauge on GTA-500m)
is recommended as a minimum. Wire runs should be kept to the minimum
practical length.
Power 12v and Ground (GND) Connection
Strip approximately 5/8” (16mm) of insulation. The positive (+) power wire is
installed into the amplifier terminal marked “12v”. The negative (–) wire is
installed into the terminal marked “GND”. The ground wire should be as short
as possible and connected directly to the chassis of the vehicle. Make sure that
the chassis connection point is free of rust, grease, dirt, paint, and other
materials that may insulate the ground wire from making proper connection.
Tighten the 12v and GND terminals with the supplied 4mm (3mm on
GTA-500m) hex wrench to secure the wire into the terminals. If the power wire
must be routed through a drilled or existing hole, use a nylon panel grommet
to prevent the insulation from fraying. Failure to do so could lead to an
electrical short if the wire insulation is worn through and the power wire is
shorted to ground.
Remote Input Connection
Connect the REMOTE trigger lead from the head unit to the amplifier using the
3mm hex wrench to tighten the connector on the power block of the amplifier.
(refer to the diagram on page 3).
Speaker Output Connection
Prepare each wire by stripping approximately
5
⁄8” (16mm) of insulation. The pos-
itive (+) speaker wires are installed into the amplifier terminal marked “SPEAK-
ER OUTPUT” / “+” (refer to the diagram on page 3). The negative (–) speaker
wires are installed into the amplifier terminal marked “SPEAKER OUTPUT” /
“-”. Tighten the “SPEAKER OUTPUT”, “+”, and “-” terminals with the supplied
3mm hex wrench to secure the wires into the terminals. If the speaker wires
must be routed through a drilled or existing hole, use a nylon panel grommet
to prevent fraying the wire insulation. Failure to do so could lead to an electrical
short if the wire insulation is worn through and the speaker wires are shorted
to ground.
WARNING! Subwoofer impedance must not fall below 2-ohms
Installation - Wiring