Filter
Top Products
RX87/RX97
3. Drill four
1
/
4
” holes for the speaker’s mounting screws. Make the large elliptical cutout with a saber saw or
nibbler (depending on the material).
4. Attach the assembly to the cutout as shown in the diagram. Use the supplied machine screws and nuts or
other hardware. Tighten the nuts just enough to seal the woofer against the mounting surface. Do not over-
tighten the hardware.
5. Attach the wires to the speaker.
6. Attach the grille front.
Snap the grille on to the grille frame from the front. Be sure to align the notch on
the grille with the logo on the grille frame.
11