Filter
Top Products
11
BASIC OPERATION (continued)
The MODE CONTROL
The MODE touchpad allows for the elimination from detection of
unwanted metal objects.
By pressing MODE, the user toggles among four different discrimination
settings.
If an object is detected during mode selection, the detector will
exit mode selection. If this happens, you will need to press
MODE again and begin mode selection over again. To avoid this,
keep the detector stationary and reduce sensitivity before
pressing MODE.
During MODE (or discrimination) selection, the SENSITIVITY INDICATOR
on the left of the display will flash continually. The detector will remain
in this discrimination selection mode until a metal object has been
detected.
The first time you press MODE, the detector will indicate the current
discrimination setting, both visually, and with distinctive tones. Each first
time the user presses MODE after powering on, the detector will do the
following:
●
1 The pyramid-shaped Sensitivity Indicator will flash continually.
●
2 A Long Tone will sound.
●
3 A High Tone will sound.
●
4 No Target Indicators will flash.
After a mode has been selected, and targets have been detected, the
detector will store the discrimination settings.
Each subsequent time the user returns to MODE selection, the detector will:
●
1 first sound a long tone, and
●
2 then indicate the stored discrimination setting.
The user can then toggle through the discrimination modes by pressing
the MODE touchpad.
The detector will store the current discrimination setting until the power
is turned off.