Filter
Top Products
Sikkerhedsforanstaltninger
4
Bestemmelser
Federal Communications Commission (FCC)
Declaration of Conformity (kun USA)
declares, that the products
comply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this
device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radioTV
technician for help.
Important
A shielded interface cable should be used in order to
ensure compliance with the limits for a Class B digital
device.
Changes or modifications not expressly approved by
Brother Industries, Ltd. could void the user’s authority
to operate the equipment.
Industry Canada Compliance Statement (kun
Canada)
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à
la norme NMB-003 du Canada.
Radiostøj (kun 220-240 volt-model)
Denne printer overholder EN55022 (CISPR
Publication 22)/Class B.
Før dette produkt anvendes, skal det sikres, at et af
følgende interfacekabler anvendes.
1 Et afskærmet interfacekabel med parsnoede
ledere, der er mærket som værende ”kompatibelt
med IEEE 1284”. (For HL-4050CDN-brugere)
2 Et USB-kabel.
Kablet må ikke være mere end 2 meter langt.
Responsible
Party:
Brother International Corporation
100 Somerset Corporate Boulevard
P.O. Box 6911
Bridgewater, NJ 08807-0911
USA
Telephone: (908) 704-1700
Product name: Laser Printer HL-4040CN and
HL-4050CDN
Model number: HL-40C
Product option: Nedre papirbakke LT-100CL