Filter
Top Products
To position the microphone in an optimal position please check Figure 1.
The carkit's main unit which contains the Digital Signal Processor should be mounted in a dry place
away from the car's heating system. Make sure that the cables are routed as far away as possible
from the vehicle’s electronic systems. This is to prevent interference. Also ensure that the cables
are not subjected to undue mechanical stress for example under seats or against sharp edges.
This carkit includes a Power Cable. The ignition sense feature prevents your Hands Free Carkit Set
from draining the vehicle’s battery by executing an auto power off after the ignition key has been
turned off. The blue wire of the power cable is used for the ignition sense feature.The blue wire is
connected via a 2A fuse to a 12 volt supply that is controlled by the ignition key. Do not connect it
directly to the high voltage sections of the ignition circuit. When the PDA is taken from the cradle,
the carkit will go in standby mode after a few minutes.
The Hands Free PDA Carkit offers a feature which can mute the car radio automatically during a
phone call, when playing audio or when a voice command is given by for example navigation
software which is installed on your PDA. To avoid interference, the yellow wire is switched to the
GND (max 50mA), which mutes the radio. When installed with the power cable it is possible to take
over the front left or front right speaker. The yellow wire in the power cable needs to be plugged in
the correct position of the vehicle’s radio ISO connector which is installed in the vehicle.
Please check your vehicle’s radio manual for the correct position. To play the audio over the
right/left front car speaker, please check table 1 how to connect the wiring. The carkit is not suitable
to use to play music on, the frequency range is optimized for voice frequencies and the signal is
coming from the carkit is a mono signal.
The phones supported by this cradle only support Bluetooth GPS Receivers.
When installing a Bluetooth GPS Receiver please follow the instructions supplied
with the product, phone and software to set it up.
Connect the FME Female plug from the CIGM-918 to the FME Female connector of the
Smartphone cradle. The Antenna should be mounted onto the vehicle’s windscreen with
the VHB tape inside the vehicle.
In vehicle’s with UV / heat protected windows the GPS reception can be influenced
and decreased. Communication settings of the PDA should be set to Serial on COM1.
Radio Muting
Connecting a Carcomm Euro-Navigator GPS Receiver.
Connecting the Carcomm CIGM-918 Quad-Band Inside-Glass Antenna.
Remarks
(optional)
(Optional)
Hands Free DSP PDA CarkitHands Free DSP PDA Carkit
Figure 1.
Table 1.
www.carcomm.nlwww.carcomm.nl
Hands Free DSP PDA CarkitHands Free DSP PDA Carkit
2
CHFS-34 HTC Tornado Noble / Qtek 8310 / i-Mate Sp5CHFS-34 HTC Tornado Noble / Qtek 8310 / i-Mate Sp5