Filter
Top Products
10
1. Raise overhead console into
approximate position and connect
wiring to components.
2. Loosely fit console against headliner.
Check that console is centered in
vehicle and matches all contours of
headliner. While supporting console
in mounting position, loosely install
using two (2) 6-32 X 3/4" screws
(item 5 pg 2) through the smaller
holes in bracket on console into
threaded clips on mounting bracket.
Inspect wiring to make sure no
chaffing has occurred near the rear
bracket (Item 3).
3. Secure front of console using one ( 1 ) # 8 X 1 1/2"
PWH screw (item 7) in front pocket of OEM
secondary pod and light assembly. See Figure 17.
4. Install one ( 1 ) # 6 x 1 1/4" PWH screw (item 6
pg 2) in dimple area at front of console through
front mounting bracket. See Fig. 17.
5. Tighten 6-32 X 3/4" screws previously installed
in step 2.
Figure 19
Figure 17