Filter
Top Products
English
30 CX501E
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
USB/iPod
No sound heard The device contains no MP3/
WMA files.
Record MP3/WMA files properly to the device.
The files are not proper MP3/
WMA format.
Use only properly encoded MP3/WMA files.
Connectors are loose. Disconnect the device and reconnect securely.
Some USB portable music
players may consume current
that exceeds the USB rating.
In this case, the unit’s
overcurrent protection circuit
operates to stop the music
playback.
Check operation of portable music player.
Sound is
interrupted or has
noise.
The MP3/WMA files are
improperly encoded.
Use only properly encoded MP3/WMA files.
The device isn’t
recognized.
The device is damaged. Disconnect the device and reconnect. If the device is
still not recognized, try replacing with a different
device.
Connectors are loose.
According to the state of
operation on the device, the
communication fault is
caused.
Disconnect the device and reconnect.
Can’t insert the
device.
The device has been inserted
improperly.
Try reversing the connection direction of the device
(usually the brand name surface should be facing
left).
The connector is broken. Replace with a new device.
Problem Cause Measure
Error Display Cause Measure
CD/MP3/WMA
ERROR 2 A CD is caught inside the CD
deck and is not ejected.
This is a failure of CD deck’s mechanism and consult
your store of purchase.
ERROR 3 A CD cannot be played due
to scratches, etc.
Replace with a non-scratched, non-warped-disc.
ERROR 6 A CD is loaded upside-down
inside the CD deck and does
not play.
Eject the disc then reload it properly.
USB/iPod
ERROR 7
(iPod mode)
The connected iPod is not
recognized.
Disconnect and reconnect the iPod.
ERROR 7 Overcurrent detection. Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
ERROR 7 Do not support the HUB
devices.
Do not use the HUB devices.
8. ERROR DISPLAYS
CX501E_EN.book Page 30 Thursday, November 11, 2010 1:16 PM