Clarion DXZ738RMP Car Stereo System User Manual


 
12 DXZ738RMP
English
6. OPERATIONS
Basic Operations
Note:Be sure to read this chapter referring to the front diagrams of
chapter 2. CONTROLS on page 5 (unfold).
CAUTION
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If
you switch the power off with the volume up,
when you switch the power back on, the
sudden loud volume may hurt your hearing
and damage the unit.
Turning on/off the power
Note:
Be careful about using this unit for a long time
without running the engine. If you drain the cars
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [FNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [FNC] button for 1 second
or longer to turn off the power for the unit.
Note:
System check
The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power is
turned on, SYSTEM CHK and Push POWER
appear in the display alternately, so press the
[FNC] button. The system check starts within the
unit. When the system check is complete, press
the [FNC] button again.
Selecting a mode
1. Press the [FNC] button to change the opera-
tion mode.
2. Each time you press the [FNC] button, the op-
eration mode changes in the following order:
Radio mode DAB mode CD/MP3/WMA
mode CD changer mode MD changer
mode DVD changer mode TV mode
AUX mode Radio mode...
External equipment not connected with
CeNET is not displayed.
Adjusting the volume
Turning the [ROTARY] knob clockwise in-
creases the volume; turning it counterclockwise
decreases the volume.
The volume level is from 0 (minimum) to 33 (maxi-
mum).
Switching the display
Press the [D] button to select the desired display.
Each time you press the [D] button, the display
switches in the following order:
Main display Clock (CT) display Main
display
Once selected, the preferred display becomes
the display default. When a function adjust-
ment such as volume is made, the screen will
momentarily switch to that function’s display,
then revert back to the preferred display sev-
eral seconds after the adjustment.
For information on how to enter a title, refer to
the subsection “Entering titles” in section
Operations Common to Each Mode”.
When CT data is not received, “CT––:––” ap-
pears in the display.
Setting the Z-Enhancer Plus
This unit are provided with 4 types of sound tone ef-
fects stored in memory. Select the one you prefer.
The factory default setting is “Z+ OFF”.
Each time you press the [Z+] button, the tone ef-
fect changes in the following order:
Z+ OFF B-BOOST IMPACT
EXCITE CUSTOM Z+ OFF ...
• B-BOOST : bass emphasized
• IMPACT : bass and treble empha-
sized
• EXCITE : bass and treble empha-
sized mid de-emphasized
• CUSTOM : user custom
• Z+ OFF : no sound effect
Adjusting the Subwoofer
The factory default setting is “SW-VOL 0
When you select one of the mode (LPF 50 Hz,
LPF 80 Hz, LPF 120 Hz).
1.
Press the [A-M] button, “SW-VOL 0” appears in
the display.
2. Turn the [ROTARY] knob to select from –6 to
+6.
3. When the adjustment is complete, press the
[A-M] button several times until the function
mode is reached.