Filter
Top Products
The CAM200 can be turned ON /OFF using a +5VDC trigger or with remote control code via the
IR IN jack located at the rear of the unit. The IR OUT is the loop out of the incoming signal from IR
IN. The IR OUT has it own buffer to isolate between IN and OUT.
Your CAM200 is factory set as being the 1
st
amp (AMP 1) to be turned on in sequence. To re-
program your unit so that it would be the 2
nd
, 3
rd
, 4
th
, 5
th
or 6
th
amps to be turned on in sequence you
have to follow this procedure.
J3 J2 J1 J0 ADDRESS RC Button Auto ON Note
X X X X 0 Amp 1 No Default setting
X X X out 1 Amp 2 No
XXoutX 2 Amp3 No
X X out out 3 Amp 4 No
X out X X 4 Amp 5 No
X out X out 5 Amp 6 No
X out out X 0 Amp1 No
X out out out 0 Amp 1 Yes Turn on when AC is live
out X X X 0 DC No DC level: 5v=on, 0=off
out X X out 1 DC No
out X out X 2 DC No
out X out out 3 DC No
out out X X 4 DC No
out out X out 5 DC No
out out out X 0 DC No
out out out out 0 DC Yes ON as plug in
IR OUT and IN (Continued)
6