Filter
Top Products
(2)
The Dayton Audio
®
DA30 is the ideal amplifier for commercial audio installations; such as classrooms, where a small, low wattage
amplifier is required. This Class D amplifier can sit on a desktop, or can be mounted on a wall or under cabinets using the included
mounting brackets. In stereo mode the DA30 delivers 2 X 15 W and in bridged mode 1 X 30 W. Two stereo audio inputs increase
versatility; 2-RCA or a single 3.5mm jack. Separate Treble and Bass controls allow the sound to be tailored to the room. The DA30’s
Auto-On feature means the unit will not sit idle wasting power when not in use.
CONNECTION
(1) Set the MODE switch to Bridge Mono or Stereo
(2) Connect your Speakers using the detachable “Phoenix” connector
(2a) For stereo operation connect the Left and Right speaker wires to the corresponding terminals
(2b) For bridge-mono operation connect the positive speaker wire to the L+ and the negative speaker wire to the R+ terminals
(3) Connect a source device to the INPUT terminals; 3.5 or RCA*
(3a) 3.5mm male plug to the 3.5mm jack
(3b) 2-RCA plugs to the two RCA jacks
(4) Connect the power supply to the 12 VDC input
*NOTE: When connected, the 3.5mm input will override the RCA inputs.
OPERATION
Once input and output connections are made it is time to use the DA30.
●
Press the POWER button to turn on the amplifier. A green LED indicator shows the amplifier is ready to use, a red LED indicator
shows the amplifier is in the “Auto-On” state to conserve power.
●
Turn on the source device and set the source output level. A green LED indicator shows the amplifier is ready to use, a red LED
indicator shows the amplifier is in the “Auto-On” state to conserve power.
●
Adjust the VOLUME on the DA30 using the rotary volume control; turning clock-wise will increase the volume level.
●
Adjust the BASS and TREBLE to set the audio to a more realistic tone using a small flat-blade screwdriver.
●
Adjust the BALANCE so the sound is evenly distributed through the room using a small flat-blade screwdriver.
After 10 minutes of inactivity the DA30 will go into the “Auto-On” state.