Filter
Top Products
77
© 2004 Directed Electronics, Inc
Tweeter Surface Mounting
NNoottee::
Use either the standard mount
housing or the angled mount housing.
1. Determine the tweeter mounting
location, then route the wires from
the crossover to the tweeter loca-
tion.
2. Remove the tweeter grill, and the
remove the tweeter from the
surface mount housing using the
tweeter tool (turn CW). Place the
surface mount housing against the
panel and mark the two holes at the
rear of the housing.
3. Drill the smaller off-center holes
using a 1/8" drill bit. These are the
mounting screw holes.
4. Drill a larger center hole using a
3/8" drill bit, insert a grommet and
route the speaker wire from the
crossover through the grommet.
5. After removing the surface mount
tweeter assembly, route the tweeter
wires through the larger hole in the
housing and connect to the speaker
wires from the crossover. (See
Figure 4.)
6. Insert the excess speaker wire into
the hole and position the housing so
the housing will not pinch the wires
after final mounting.
7. Attach the housing using the
supplied screws of the correct length
for a solid mount.
8. Insert the tweeter into the housing
and use the tweeter tool and rotate
the tweeter CCW till locked. Attach
the tweeter grill.
TWEETER
Wiring
PanelTweeter
Wiring
Mounting
Screws
Surface Mount Housing
Tweeter
Grill
Tweeter
Tool
FIGURE 3—TWEETER SURFACE MOUNTING