Filter
Top Products
1122
© 2005 Directed Electronics, Inc. all rights reserved
If selected while the remote power
is on, the amplifier will continue
playing until the remote power is
turned off.
To Clear Valet Mode, Disable Valet
mode on the alarm, then cycle the
remote power line off then on
again. The amplifier will power up
normally after the Turn On Delay
time has expired.
7.
AAnnttii--tthheefftt --
Selecting ON, allows the
amplifier to monitor Arm and
Disarm signals from the alarm,
rendering the amp in-operable if
stolen. When OFF, these signals are
ignored. OFF is the factory default
setting.
When main power is removed while
the unit is armed, the unit is placed
into a "stolen state". The ESP
®
Status indicator will blink rapidly,
and the amplifier will not continue
its power up sequence. Also when
there is currently an ARM signal
active on the bus, the amplifier
cannot be written to by the
Bitwriter
®
.
To reactivate the amplifier, connect
the alarm that was used to arm the
amplifier, and press the disarm
button. Ensure the remote line is
off(turn it off if this is not the
case), and then turn the amplifier
on. The amplifier should power up
normally after the Turn On Delay
expires.
8.
TToopp LLiigghhtt OOppttiioonnss --
i. Light On W/Service Code
ii. Light Off W/O Service Code
iii. Light On, W/O Service Code
iv. Light Off, W/Service Code
Default is Light On, W/O Service Code
The amplifier contains the ability to
control the lights on top of the unit
behind the logo badge. In addition
to custom tailoring many other
features, your Directed Dealer can
use a Bitwriter
®
(V2.0 or later) to
setup the top light so that it is
either on or off when the amplifier
is on or off. In addition, the top
light can indicate when the ampli-
fier is in any of the fault shutdown
modes, or can display the service
code when this is being accessed.
i. This option has the top light lit
when the unit is on(remote line
on), and indicates service codes
and faults on the top light.
ii. This option has the top light unlit
when the unit is on, and doesn’t
indicate service codes or faults on
the top light.
iii. This option has the top light lit,
but does not indicate service codes
or faults on the top light.
iv. This option has the top light