Directed Electronics 202 Car Amplifier User Manual


 
5
© 1999 Directed Electronics, Inc
LIMITED TWO YEAR CONSUMER WARRANTY
Directed Electronics, Inc. (DEI) promises to
the original purchaser, to replace this
product should it prove to be defective in
workmanship or material under normal use,
for a period of two years from the date of
purchase by the dealer as indicated by the
date code marking of the product PRO-
VIDED the product was installed by an
authorized DEI dealer. During this two year
period, there will be no charge for this
replacement PROVIDED the unit is returned
to DEI, shipping pre-paid. If the unit is
installed by anyone other than an autho-
rized DEI dealer, the warranty period will be
1 year from date of purchase by the dealer
as indicated by the date code marking of
the product. During this 1 year period, there
will be no charge for this replacement PRO-
VIDED the unit is returned to DEI, shipping
pre-paid. This warranty is non-transferable
and does not apply to any unit that has
been modified or used in a manner contrary
to its intended purpose, and does not cover
damage to the unit caused by installation or
removal of the unit. This warranty is void if
the product has been damaged by accident
or unreasonable use, neglect, improper
service or other causes not arising out of
defects in materials or construction. ALL
WARRANTIES INCLUDING BUT NOT
LIMITED TO EXPRESS WARRANTY,
IMPLIED WARRANTY, WARRANTY OF MER-
CHANTABILITY, FITNESS FOR PARTICULAR
PURPOSE, AND WARRANTY OF NON-
INFRINGEMENT OF INTELLECTUAL
PROPERTY ARE EXPRESSLY EXCLUDED TO
THE MAXIMUM EXTENT ALLOWED BY
LAW, AND DEI NEITHER ASSUMES NOR
AUTHORIZES ANY PERSON TO ASSUME
FOR IT ANY LIABILITY IN CONNECTION
WITH THE SALE OF THE PRODUCT. DEI
HAS ABSOLUTELY NO LIABILITY FOR ANY
AND ALL ACTS OF THIRD PARTIES
INCLUDING ITS AUTHORIZED DEALERSOR
INSTALLERS. Unit must be returned to DEI,
postage pre-paid, with: consumer's name,
telephone number, and address, authorized
dealer's name and address, and product
description. IN ORDER FOR THIS WAR-
RANTY TO BE VALID, YOUR UNIT MUST BE
SHIPPED WITH PROOF OF INSTALLATION
BY AN AUTHORIZED DEI DEALER. ALL
UNITS RECEIVED BY DEI FOR WARRANTY
REPAIR WITHOUT PROOF OF DEI DEALER
INSTALLATION WILL BE COVERED BY THE
LIMITED 1 YEAR PARTS AND LABOR WAR-
RANTY. Note: This warranty does not cover
labor costs for the removal and reinstalla-
tion of the unit. BY PURCHASING THIS
PRODUCT, THE CONSUMER AGREES AND
CONSENTS THAT ALL DISPUTES BETWEEN
THE CONSUMER AND DEI SHALL BE
RESOLVED IN ACCORDANCE WITH CALI-
FORNIA LAWS IN SAN DIEGO COUNTY,
CALIFORNIA.
© 1999 Directed Electronics, Inc
SPECIFICATIONS
4
Crossover Slope 12 dB/octave
Crossover Frequency 35Hz-500Hz, X1 mode
350Hz-5kHz, X10 mode
Bass equalization -0,+12dB@40Hz,variable
Frequency response 10Hz-50kHz, ± .5 dB
THD 0.02%
Signal-to-Noise Ratio 100dB(high-pass),90dB(low-pass)
Separation 75 dB
Input Sensitivity 200mV ~ 6V RMS
Input Impedance 47k ohm
Output Impedance 470 ohm
Maximum Output Voltage 8V RMS
Supply Voltage 9VDC to 16VDC
Dimensions (mm) 162 W x 40 H x 125 D
30 volt balanced circuit design
Low-noise J-FET op-amps
X10 crossover frequency range switches
Mono/stereo low-pass output switch
Phase inversion low-pass output switch
Separately adjustable filters for greater tuning flexibility
Remote out with delay to turn on amplifiers.
Gold-plated power terminals and RCA jacks
FEATURES